1

Make sure the top surface of the ramp is clean and free of grease. Windex(TM) or a similar product works well.

2

Peel the paper liner from the back of the non-skid tape and attach to the center of each braking section.

3

Turn all of the stop sections over and position a binding plate on each end. Begin threading the nuts onto the screws.

4

Match all of the nuts and screws before tightening the screws with a Phillips screwdriver. You may need a 5/16" wrench to prevent the nuts from turning.

5

Turn the completed stop section over and attach to the end of the track using a screw in the middle of each lane attached to binding plate under the track.